Κάντε την διαφορά

Email: sales@thunderlaser.gr

troubleshooting troubleshooting
Βρίσκεστε εδώ:Αρχική > troubleshooting > The laser won’t turn on
Image-1

Thunder Laser Video


Πώς να επιλέξετε μία αξιόπιστη μηχανή κοπής laser

ΠΡΟΒΟΛΗ
▷ Πώς να επιλέξετε μία αξιόπιστη μηχανή κοπής laser
Image-1

Thunder Laser Video


Πώς να εγκαταστήσετε την κεφαλή HR

ΠΡΟΒΟΛΗ
▷ Πώς να εγκαταστήσετε την κεφαλή HR

The laser won’t turn on

Δημοσιεύθηκε:2017/01/11 troubleshooting Προβολές:1359

This problem is probably caused by one of three conditions:

1.Emergency Stop key is pressed in;

2.The fuse in power plug blew out or circuit breaker is off;

3.Defects of the Emergency Stop key or Main switch.


1.Make sure the Emergency Stop Switch is not pressed in.



2.

①Please check if the power plug just like the picture below, if yes, mare sure the circuit breaker in the back of the machine is not turned off.



②If your machine was bought before November 2016, please test if there ‘s 115V/230V power input by the following image or not? if there’s no 115V/230V power input, please check the fuse and replace it(see pic to find where’s the fuse).



3.If above are all normal, please test if there ‘s 115V/230V power input(Switch be off, test the sides of “O”) by the following image. If yes, the Emergency Stop key is fail; otherwise, the Main switch is fail.