Κάντε την διαφορά

Email: sales@thunderlaser.gr

troubleshooting troubleshooting
Βρίσκεστε εδώ:Αρχική > troubleshooting > How to Replace the rollers and adjust the X Axis Shaft?
Image-1

Thunder Laser Video


Πώς να επιλέξετε μία αξιόπιστη μηχανή κοπής laser

ΠΡΟΒΟΛΗ
▷ Πώς να επιλέξετε μία αξιόπιστη μηχανή κοπής laser
Image-1

Thunder Laser Video


Πώς να εγκαταστήσετε την κεφαλή HR

ΠΡΟΒΟΛΗ
▷ Πώς να εγκαταστήσετε την κεφαλή HR

How to Replace the rollers and adjust the X Axis Shaft?

Δημοσιεύθηκε:2017/01/05 troubleshooting Προβολές:1377

1.Please check before adjustment

①Hold and shake it to check if it becomes loose.(Can’t be wobble obviously)



②. In the back of X Axis Shaft have four rollers,both of them should locate on the rail.(can move smoothly)



2. Introduction of the X Axis Shaft



①The X Axis Shaft

②Eccentric gears, which was for adjusting the tension of X Axis Shaft

③Rollers

The tools you needed as follow:(M2/M3 Allen Wrench and Crimp Tool inside the tool box)



3. Adjustment of the X Axis Shaft

①. Make sure the all screws of the four Rollers are tight enough.

However, the X Axis shaft is loosen.

②. Adjust the two Eccentric gears as follow:

First , Hold the screws back of the Eccentric gears;

Next, loose the A screws ;

Then, Rotate B by Crimp Tool to tighten the X Axis Shaft.



Make sure all the Rollers are at the same tension

③. repeat step 1 to check again.